Xaircraft STELLA Bedienungsanleitung PDF herunterladen (Seite 9)

Quick Guide

STELLA is currently the simplest brushless gimbal in the world. It is operational after a few short steps listed below.

1. Install the mounting components, GoPro Hero 3/3+ and connect STELLA to your receiver.

2. Configure your radio according to what type of receiver you use (Standard receiver or SBUS receiver).

3. Power on your transmitter, then power on STELLA, and wait for the systems check to finalize. This will take

approximately 10 seconds.

※ When powering on STELLA, keep GoPro as stable as possible. During the systems check any vibration or

movement to STELLA will cause the systems check to fail.

4. Check your transmitter controls are working correctly.

Troubleshooting

Symptoms

Possible Reasons

Solutions

10 seconds after powering on

STELLA, camera is still not levelled

or simply not responding.

There may have been some

movement or vibration when

powering-on STELLA, system check

has failed.

Keep STELLA stationary when

powering-on.

Camera keeps drifting.

1. There may have been some

movement when powering-on

STELLA.

2. The trim setting on your remote

controller is too high or

abnormal.

1. Keep STELLA stationary when

powering-on.

2. Adjust stick trim on the

controller.

Camera is not levelled after System

check.

1. STELLA is not correctly

configured.

2. STELLA is damaged.

1. Reset the initial angle in the

configuration software.

2. Contact your dealer.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Xaircraft STELLA Bedienungsanleitung Seite 9